Today I have easy tags for you to make with some scraps of paper and the Stampin’ Up! Scalloped Tag Topper Punch.
It is a great project to use up any 1/2” or 3/4” strips of Designer Series Paper you have sitting about. Plus if you have strips of 2 3/4” or 3” Whisper White strips as small as 1 15/16” long, you are set.
With Christmas just over a week away I had to start wrapping & tagging the gifts, but I didn’t have any Christmas tags in my wrapping supplies. Instead of running out and getting some at the store, I was able to whip these up in about 30 minutes -clean up & sizing/design included!
I started with one strip of 3”x10” Whisper White Thick cardstock & two strips which were 2 3/4”x10. As long as you have a piece bigger than the final 1 15/16” long Tag you are fine.
I placed Designer Series Paper as shown in the diagram before I cut to the smaller tag size. Doing this as a full piece saved me a little time. Once at this stage, I cut each to the 1 15/16” length and then punched the largest white end using the Scalloped Tag Topper Punch.
From this point, I The stamped to/from from Cookie Cutter Christmas and added some ribbon. Of course, you could also just hand write the to/from & use packaging Christmas ribbon if you’re in a pinch and have them on hand.
I didn’t have to run to the store AND I used up some scraps I had on hand. Now, when I need tags for other occasions I’ve already figured out the sizing and will easily be able to tag any party gift by just switching out the Designer Series Paper to fit the occasion. Thank you Scalloped Tag Topper Punch!
I hope this helps you during times you need tags. Especially Christmas Eve when many of you are up all night wrapping gifts!
Until next time…